This will be 3 rod joints accepting 1/2 inch rod on one and and allowing 3/8 rod out the other end at angles of 5, 7.5, and 10 degrees. All the stainless screws are turned down 1/2 inch socket head cap screws.
At this point the 9 inch piece of 1 inch stainless round has had 3 flats machined on it and has been cold cut to rough length.
Next it will be finished to length and chamfered in the hardinge. The stright end will also be drilled in the lathe. After that, its off the the mill, for all remaining operations.
